Data from the Gambas runtime environment...
umount2: no such file or directory
umount: sr0: not found
ls: can not access /mnt/sdb1: no such file or directory
Results of probepart
Device Boot Start End Blocks ID System
/dev/sda1 * 1 261 2096451 82 linux swap
/dev/sda2 262 59041 472150350 5 Extended
/dev/sda3 59042 60801 1413200 7 HPFS/NTFS
/dev/sda5 29721 44381 117764482 83 Linux
/dev/sda6 14922 29720 118872936 83 Linux
/dev/sda7 262 14921 117756387 83 Linux
/dev/sda8 44382 59041 117756418 83 Linux
When the install finished, I choose vxconf from the menu and set up fglrx Driver 8.56.1. I have an ati HD 3200 in this machine.
Upon reboot kwin poped up a prompt detailing that it had crashed or was unstable and the screen froze.
I'm trying again now.
The problem with kwin was only because I have two monitors attached this machine. Unplugged the vga cable to one and no problem.
Could not launch amdcccle, however, with the driver that was loaded during the install. I get a warning that Catalyst Control Center Linux edition could not be launched because of one of the following. No ATI graphics diver or ati driver is not functioning properly.
I downloaded the recommended driver from the ati site (Driver 8.65 fromthe file "ati-driver-installer-9-9-x86.x86_64.run") and everything works perfect.