Couple weeks ago I bought a new laptop, and put a Gigabyte ws30n wireless card in it, since oxfordtech.com said it is supported in linux.
Well, this card kept me busy for a week. I tried ndiswrapper(the win xp driver is caller rt2860 and could be downloaded from the Gigabyte website
), without much luck. It kept freezing when trying to connect to my wireless router.
This card is based on Ralink RT2860 chipset, so I decided to try their drivers(version 220.127.116.11, could be downloaded from the Ralink website
). While they do have opensource drivers for this card, they are rather outdated and only compile with 2.6.29 kernels and older.
At this point I was almost ready to give up. Hovewer, I thought I would check maybe it would work in other distros. I installed ubuntu and sure enough the card worked out of the box. I was almost ready to cry.
It was using rt2860sta module. After comparing ubuntu and vector kernel config files I found that the staging drivers for this card were disabled in the VL kernel.
After that it was just a matter of enabling them:
Device Drivers ---> Staging Drivers --->uncheck Exclude stading drivers from being build
Device Drivers ---> Staging Drivers --->check Ralink 2860 wireless support
After compiling the kernel, the module loaded without problems and the card worked flawlessly ever since.
I also run into a problem with wicd - it was stuck on "Obtaining IP Adress" and not connecting to my 2wire at&t router
What solved it is changing WEP(Passphrase) to WEP(HEX) in the advanced settings.
lspci output for the card:
03:00.0 Network controller: RaLink Unknown device 0681