Visit our home page for VL info. For support and documentation, visit the Vector Linux Knowledge Center or search the Knowledge Center and this Forum using the search box above.
Documentation suggests that ext2 and ext3 filesystems may be converted: https://ext4.wiki.kernel.org/index.php/Ext4_Howto I have not tried this myself though. For simply ext4 support in kernel: Kernel 18.104.22.168 on my VL box mounts and reads it just fine. After upgrading e2fsprogs to version 1.41.3 (sw 12.2) I can also create ext4 systems. As far as your root filesystem.. I agree with M0E-lnx; pick a version that supports ext4 during installation. Converting afterwards would be complicated. I really don't see any good reason to do so.@nightflier: Thank you! I only needed to be able to read partitions formated with the ext4. I forgot I can install Vector light on ext3, THEN upgrade the kernel and make it read and write other ext4 partitions. Am I correct? Besides, ext3 uses slightly less resources it seems?Regards,Drazen
@Drazen: Correct. An upgrade to kernel 22.214.171.124 will give you the ability to access ext4 partitions. Follow this guide:http://forum.vectorlinux.com/index.php?topic=10385If you also want to be able to create ext4 filesystems, upgrade your e2fsprogs using this package:http://slackware.osuosl.org/slackware-12.2/slackware/a/e2fsprogs-1.41.3-i486-1.tgzThis article highlights some of the performance differences between ext3 and ext4:http://www.phoronix.com/scan.php?page=article&item=ubuntu_pentium4_old&num=1It also illustrates our difference in opinion regarding what hardware is considered "antiquated"