VectorLinux
July 31, 2014, 09:11:10 am *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: Visit our home page for VL info. To search the old message board go to http://vectorlinux.com/forum1. The first VL forum is temporarily offline until we can find a host for it. Thanks for your patience.
 
Now powered by KnowledgeDex.
   Home   Help Search Login Register  
Please support VectorLinux!
Pages: [1]
  Print  
Author Topic: rc.X ==> Going to multiuser GUI mode....  (Read 1613 times)
666lawyer
Member
*
Posts: 60


« on: November 12, 2010, 07:44:04 am »

Instale Vector Linux pero cuando booteo se queda colgado en el Sujject?Huh. Alguna idea.


Pentinun II
Disco 8 gb
Monitor Compaq
Logged
newt
Vectorian
****
Posts: 1132



« Reply #1 on: November 12, 2010, 09:41:34 am »

Sounds like an issue when starting X on the installer. Unless there is some alternative installer options then you may be out of luck. In the past there as always been the safe bet of the TUI installer, but I'm not certain if this was ever made functional for VL6SOHO (I don't think it was).  Other possibilities are booting using a specific parameter that will drop you at the shell prior to starting X which would give you a way of troubleshooting your problems with X and, although getting to the shell is simple enough, the task of configuring xorg from the shell is not trivial. I believe that the boot parameter to get you to the shell prior to X starting is either 'gui2' or 'gui 2' (no quotes, of course).
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!