Please login or register.

Login with username, password and session length
Advanced search  


Visit our home page for VL info. For support and documentation, visit the Vector Linux Knowledge Center or search the Knowledge Center and this Forum using the search box above.

Pages: 1 [2]

Author Topic: wicd Bad!  (Read 2730 times)


  • Administrator
  • Vectorian
  • *****
  • Posts: 4166
Re: wicd Bad!
« Reply #15 on: April 09, 2012, 02:55:11 pm »

Internet search on that adapter reveals that a lot of people experience problems with it. 
This is a little outside my comfort zone, maybe someone with more experience in this may jump in.

Some thoughts:
It could be an issue with missing firmware or mis-identification of your device, check dmesg for errors.
Looking at the output of your lsmod commands, it appears that VL6 uses the rt73usb module.



  • Member
  • *
  • Posts: 94
Re: wicd Bad!
« Reply #16 on: April 09, 2012, 07:05:06 pm »

 I came across a Slackware related post where it was suggested to blacklist the module in /etc/modprobe.d/blacklist. I did that in Vector, but nothing changed.


  • Member
  • *
  • Posts: 2
Re: wicd Bad!
« Reply #17 on: April 21, 2012, 05:55:33 am »

I had the same problem with a realtek wna1100
In terminel, I typed  ifconfig wlan0 up
In wicd, I chose network then wireless interface and type wlan0 and it worked.
Maybe that can help you
Pages: 1 [2]