Please support VectorLinux!

Author Topic: network connection difficulty - newbie  (Read 5853 times)

bigpaws

  • Vectorian
  • ****
  • Posts: 1868
Re: network connection difficulty - newbie
« Reply #30 on: April 13, 2013, 08:52:05 pm »
The reason only one ethernet card shows up is that you did not enable the
second one. That is a default setup.

Generally speaking ethernet just works. The only time I have had to
do any intervention was a wrong module (driver) loaded. This may
be your problem.

Please list the ethernet cards ( You can use lspci as root for this info)
name, make and model number.

To enable the second ethernet card as root type:
iconfig eth1 up

Now test by looking at ifconfig again you should see
lo
eth0
eth1

You can try getting an ipaddress by using this command:

dhcpcd eth1

You will not get a return response. It may look like it
died.

Look at ifconfig again to see if you got an ipaddress.

Bigpaws