I've installed VL 4.0 (it is on /dev/hdb1 with ext3 file system)
My windows95 system is on /dev/hda1 (with FAT16).
I can boot to Windows OK (after I restored by MBR) directly from /dev/hda (where MBR resides)
I can boot to VL 4.0 using a book diskette.
/dev/hda is a 1.7GB hard drive with 1 primary partition in FAT16
/dev/hdb is a 8.4GB hard drive where partition 1 is ext3, partition 2 is swap, and partition 3 is ext 3 (currently empty).
However, whenever I try to install LILO (after configuring it in VL) to the MBR (/dev/hda), next boot gives me this output:
"L 40 40 40 40 40 40 40 40 40 40 " and this repeats for a few lines.
As far as I can tell 40 is the "disk seek error".
Any ideas what is wrong with my setup?