Helo!
I have VectorLinux 5.8 Standart Edition. This Distribution offer CUPS as printing-system.
This printer must be recognized automatically, but this don't happened. I succeeded in doing this an days ago during a previous installation.
I try to install my HP deskjet 3325,USB with CUPS, but this failed. Printer is hooked and switched on, in Printing System Selection I select CUPS adjustment. I type
http://localhost:631 in my Browser. After this I go to Administration->Add printer ->Device. Here I have:
AppSocket/Hp JetDirect
Internet Printing Protocol (http)
Internet Printing Protocol (ipp)
LPD/LPR Host or Printer
SCSI Printer
Serial Port #1
Serial Port #2
Windows Printer via Samba
It's looked as not any USB-Device gives.I follow the CUPS-installation-steps to the second step „Device“. Here I cann't my USB-device feed – this don't exist.
The command
lsusb
gives:
Bus 1 Device 2: ID 03f0:7004 Hewlett-Packard DeskJet 3320c
I type:
root:# lpinfo -v
and have:
network socket
network http
netzwork ipp
network lpd
direct scsi
serial serial:/dev/ttyS0?baud=115200
serial serial:/dev/ttyS1?baud=115200
network smb
The command:
ps ax | grep cups
gives:
2417 ? Ss 0:00/usr/sbin/cupsd
2663 tty2 S+ 0:=0 grp cups
I type:
gs -v
and have:
ESP Ghostscript 8.15.3 (2006-08-25)
Copyright © 2004 artofcode LLC, Benicia, CA. All rights reserved.
The command
lpinfo -m | grep 3325
gives:
foomatic-ppds/HP/HP-DeskJet_3325-hpijs.ppd.gz HP DeskJet 3325 Foomatic/hpijs (recommended)
In /proc/config.gz among other things:
USB Device Class drivers
CONFIG_USB_PRINTER=m
I am newbe and please simple!
System-Configuration: Pentium 2-Prozessor, 128 MB RAM, 20 GB Harddrive(512 MB for Swap-Partition, 6 GB for VectorLinux, 6 GB für SaxenOS), Motherboard GA-686LX4, Radeon VE w/64MB DDR, PCI 1, CMI8738 /PCI-6ch-LX, PCI 3, DVD-ROM BDV316C( Master on second IDE-channel), Motorola MOT PCI-3, PCI 2 .
I need your help!
Thank you!