Please support VectorLinux!

Author Topic: lm_sensors/coretemp  (Read 11882 times)

wcs

  • Packager
  • Vectorian
  • ****
  • Posts: 1144
Re: lm_sensors/coretemp
« Reply #15 on: July 31, 2007, 01:41:47 pm »
Quote
Manual modprobe commands appear to work

Do they also show up when you do lsmod?

nubcnubdo

  • Vectorian
  • ****
  • Posts: 675
Re: lm_sensors/coretemp
« Reply #16 on: August 01, 2007, 04:37:51 am »
hanumizzle helped me set up lm-sensors for gkrellm, but that thread was lost recently.

Calibration of GKrellM Temperature Sensor: Adjust "Offset" when computer is cold, just after boot. Adjust "Factor" when computer is warmed up, after ~30 minutes running.
« Last Edit: August 01, 2007, 05:24:41 am by nubcnubdo »

retired1af

  • Packager
  • Vectorian
  • ****
  • Posts: 1280
Re: lm_sensors/coretemp
« Reply #17 on: August 01, 2007, 04:54:41 am »
Quote
Manual modprobe commands appear to work

Do they also show up when you do lsmod?

Yep...

i2c_i801                8464  0
i2c_core               18816  5 eeprom,lm90,i2c_dev,nvidia,i2c_i801


root:# sensors -f
No sensors found!
Make sure you loaded all the kernel drivers you need.
Try sensors-detect to find out which these are.

ASUS K73 Intel i3 Dual Core 2.3GHz

wcs

  • Packager
  • Vectorian
  • ****
  • Posts: 1144
Re: lm_sensors/coretemp
« Reply #18 on: August 01, 2007, 05:25:56 am »
Other than modules not being loaded, I cannot think of any other reason for it to work.
Are those the only modules detected by sensors-detect? What shows up in your /etc/sysconfig/lm-sensors?

I suppose it could also be that sensors-detect is actually getting it wrong. So far as I remember it outputs a confidence level for the modules it detects. Are those high in your case?