April 18, 2015, 10:59:55 am *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: Visit our home page for VL info. To search the old message board go to The first VL forum is temporarily offline until we can find a host for it. Thanks for your patience.
Now powered by KnowledgeDex.
   Home   Help Search Login Register  
Please support VectorLinux!
Pages: [1]
Author Topic: Is there any FAQ about Wireless Networking through KDE control center.  (Read 1446 times)
Posts: 1

« on: September 06, 2007, 07:33:14 pm »

VL 5.8-SOHO-RC2 ( kernel).

Network Setting in KDE always starts with ath0 disabled and eth0 configured by dhcp. I don't use ethernet card but can't disable eth0. When I try to disable it, it's  enabled again in about 10sec.

Ath0 is configured manually (static IP). Click "apply" and I set. After rebooting I need to repid the same process. VASM works good, doesn't say anything and change nothing.

Can anyone point a finger to the "help" direction? 

Pages: [1]
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!