Please support VectorLinux!

Author Topic: Is there any FAQ about Wireless Networking through KDE control center.  (Read 1452 times)

Linux_oid

  • Member
  • *
  • Posts: 1
VL 5.8-SOHO-RC2 (2.6.20.4 kernel).

Network Setting in KDE always starts with ath0 disabled and eth0 configured by dhcp. I don't use ethernet card but can't disable eth0. When I try to disable it, it's  enabled again in about 10sec.

Ath0 is configured manually (static IP). Click "apply" and I set. After rebooting I need to repid the same process. VASM works good, doesn't say anything and change nothing.

Can anyone point a finger to the "help" direction?