i have a dell inspiron 1505, with a dual core processor (T2050). I just installed vector-linux, but I don't know how to make my cpus run in c4, at 800mhz instead of 1600 (fullspead). vcpufreq says something like:
"unable to set desired scaling governor... try modprobing corresponding governor module:
# modprobe cpufreq_userspace"
however there is no such module. i tried inserting all cpufreq* modules and everything found in /lib/modules/126.96.36.199/kernel/drivers/acpi directory, but still vcpufreq doesn't work.
hereis the full output from vcpufreq-load
vcpufreq-load enabled in config...
sh: /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor: No such file or directory
Unable to set desired scaling governor...
try modprobing corresponding governor module:
# modprobe cpufreq_userspace
sh: line 1: try: command not found
Set scaling governor: userspace
sh: /sys/devices/system/cpu/cpu0/cpufreq/scaling_setspeed: No such file or directory
Set scaling speed: 0 (0 MegaHertz)
sh: /sys/devices/system/cpu/cpu0/cpufreq/scaling_max_freq: No such file or directory
Set scaling max freq.: 0 (0 MegaHertz)
sh: /sys/devices/system/cpu/cpu0/cpufreq/scaling_min_freq: No such file or directory
Set scaling min freq.: 0 (0 MegaHertz)
what modules should I load? how can I fix this problem?