ok i am using vectorlinux 5.9 lite on my dinosaur lappy, and i have been following the tut for setting up the my wireless card (pci)
ok so i do the lspic -n and i notice its the same as the driver that i installed in ndiswrapper -l the driver says
"wg311v3: driver installed
this is slightly different from what is on the tut
2802w driver installed
airplus driver installed
bcmwl5 driver installed
gplus driver installed
mrv8ka51 driver installed, hardware present
net8180 driver installed
netadm11 driver installed
netdlwl driver installed
ntpr11ab driver installed
w70n51 driver installed
and that goes on to say if it aint on the same line the card aint being detected
"If it doesn't have "hardware present" on that line, then your card is not being detected."
i mcedit'ed in the alias wlan ndiswrapper in the /etc/modprobe.conf
thinking that would fix it... nope
because i did the following
it takes along time
and it says killed
i think i what is going wrong is that the card's drivers might not be comunicating correctly, but thats just a guess...
i am quiet stumbed here. lol help please.
if you need me data of the setup.. please ask.. and you shall have.
EDIT- dumb me i got a 511v2 card... does anyone know so where i can get the .INF file needed for this NIC? i got only a .exe from netgear...