VectorLinux
October 23, 2014, 12:15:55 am *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: Visit our home page for VL info. To search the old message board go to http://vectorlinux.com/forum1. The first VL forum is temporarily offline until we can find a host for it. Thanks for your patience.
 
Now powered by KnowledgeDex.
   Home   Help Search Login Register  
Please support VectorLinux!
Pages: [1]
  Print  
Author Topic: Howto: setting nic speed permently  (Read 3019 times)
cendoubleu
Member
*
Posts: 6


« on: November 10, 2006, 03:39:09 am »

just thought I'd post this for anyone who has similar problems to me. When any distro detects my nic card, it always autonegotiates to 100Mb full duplex. For some strange reason, my router will only talk to this or any pc at this location (in the den about 30+ feet from the router) at 10Mb. All other pc's on the router talk at 100Mb. Go figure!. So I edited /etc/rc.d/net/eth0 (or eth1 etc if that is connected to the network) and added the following lines:

mii-tool eth0 -F 10baset-fd
dhcpcd

On boot up, the nic negotiates via DHCP and communicates no probs. I did try ethtool, but that doesn't seem to work with any of the nic cards I have tried.

Hope this helps anyone else with this prob. There are probably other ways to do this but I found this the easiest.

Charlie
« Last Edit: November 11, 2006, 06:11:43 am by easuter » Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!