(I don't know wether this is the right place to report
I burned a CD of data with K3B under VL6.0, with the option
to check the CD after burning. When the burning phase finished,
the CD drive opened (which is normal) but did not close
immediately to re-read the CD and check the written data
(which is not).
I chould check by hand the data written on the CD (mount the
CD, and use the "diff -r" command in a console): the data are OK,
so only the verification process did malfunction.
To pin down the problem, I made two experiments:
1) burn a CD under VL5.9 (that I keep as a backup on a separate
partition): everything went smooth, burning and verifying. So,
my CD drive seems OK.
2) install VL6.0 on a separate partition for test, and burn a CD
immediately using that pristine installation: I observed the malfunction
So, there seems to be some partial incompatibilyty between
VL6.0 and K3B. Did someone observe the same behaviour ?
Old pentium 3 @ 700 MHz, 384 MB ram